First I want to give props to fasteddy516 for the design.

File and Prints of models not to sell or resale

This was enlarged to print on a gMax XT+ for a full size shield. Defiantly use a brim or glue to hold down to bed, as it tends to lift. Pieces were put together with 2 part epoxy and 3/8" wooden dowel rods. Ratchet straps were used to clamp it together. Blend the seams together starting with Bondo brand fiberglass bondo and sanding. A few coats of high build primer with sanding in between. 2 coats of Rust-oleum stone texture finish and 2 coats of same brand matte finish clear. Size ends up about 3 ft tall, 2 ft wide, and 2.5 inches deep. Props to fasteddy516 for model 2677486

Print Settings

Printer:

gMax Xt+

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

5-10%

Filament:

MatterHackers PLA

Various

Notes:

Brim and/or glue to keep from lifting
Long print time

Category: Costume