This is a 5.5-inch diameter irrigation ring designed to be used with 0.25-inch ID Tubing. Use a small ball valve to adjust the flow rate of the water through the ring. This works perfectly with my 2-Liter Soda Bottle To 0.25-Inch ID Tube Adapters and 2-Liter Soda Bottle Clamp Mount
A T-Stake Hold Down .stl file is included and should be used to secure the irrigation ring to the soil.
Tested to work with the following tubing:
- JoyTube ¼" ID Silicone Tubing - https://amzn.to/379qGuq
- Rollerflex ¼" ID Crystal Clear Vinyl Tubing - https://amzn.to/3uOudX9
- Outfandia ¼" ID Irrigation Tubing - https://amzn.to/3iWKAeP
- Feelers Drip Irrigation ¼" OD Switch Valve - https://amzn.to/3LD5I69
*Note: As these models need to be printed watertight, and quite sturdy, I recommend printing with 6 perimeters, and 5-6 top and bottom layers.
*Note: Add a support enforcer in Prusa Slicer to support the tube inlet nub as pictured in the Support Enforcer Image located in the image gallery.
*Note: This post contains Amazon Affiliate links that support The Makers Workbench via a small commission from any sales they help generate.
Design File Included: .stl .f3d, step, .skp and obj files.
Follow The Makers Workbench on:
I have only tested this model using the default 0.20mm 100mm/s preset in Prusa Slic3r 2.3.3 with the following amendments made.
Print Settings
- 6-perimeters
- 5-top layers
- 5-bottom layers
- 20% infill
- Rectilinear Infill
- Monotonic Top and Bottom Pattern
- Detect Bridging Perimeters - True
Support Settings - Set Support for Enforcers Only
- Contact Z Distance - 0.2mm
- Pattern Spacing - 2mm
- Pattern Angle - 0-degrees
- Interface Layers - 2
- Interface Pattern Spacing - 0.2mm
*Note: Add a support enforcer in Prusa Slicer to support the tube inlet nub as pictured in the Support Enforcer Image located in the image gallery.
PLA Used: Polymaker Polyterra Eco-Friendly PLA - https://amzn.to/3qPYtzV
5.5-Inch Irrigation Ring With 0.25-Inch Tube Inlet
by TheMakersWorkbench · original on Printables ↗
Household / Outdoor & Garden
♥ 199⬇ 960🖨 1 prints
Print profiles
5.5-Inch-Drip-Ring-0.25-Inch-Tube-Inlet.objDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
T-Stake-Hold-Down.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
5.5-Inch-Drip-Ring-0.25-Inch-Tube-Inlet.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print