The shops here are closed because of quarantine and I only had an M8 thread and M8 nuts at home, so I created a version which uses M8.
Everything is the same, except the holes and nut fittings are bigger.
I fixated the knob onto the thread adding a jam nut next to it.
Designed with Fusion 360
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
40% Gyroid
Filament: Azurefilm PLA PLA Orange
Notes:
My print warped a lot but is still usable
Ski tuning vice with M8 nuts
by mat7ej · original on Printables ↗
Sports & Outdoor / Winter Sports
♥ 111⬇ 581🖨 5 prints
Print profiles
Mover_v5.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Stator_v9.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
knob_v4.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
protector_v5.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print