The two files provided are for the printed case and a laser cut screen protector.

The norns Shield is secured in place using 4 M2.5 * 5mm screws, no standoffs are required, only the Shield PCB is screwed in, the Raspberry Pi sits on the printed ledges, it may rattle slightly but ive not found this to be a problem.

The screen protector is friction fit, a very small dab of glue could be used to make sure it doesent move, i didnt find this necaserry.

Make sure to remove the SD card before inserting the RPI, its a snug fit and you may damage the SD card otherwise.

Norns Shield angled case

by Fisher · original on Printables ↗

Gadgets / Audio

♥ 26⬇ 571🖨 4 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗caseraspberrypiraspberrypicasenornsmonome

Print profiles

Angled Norns Case.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print