Derelict Lightsaber Hilt from Star Wars: The Od Republic

This is my attempt at the Derelict Lightsaber Hilt from Star Wars: The Old Republic. You just need to print one of each part, everything should just slide into each other, but you may need to sand it and glue some parts. Here’s my assembly and painting videos https://www.youtube.com/watch?v=uQ2h70HroX0

If you guys liked this file, be sure to post a make and check out my other files.

Print Settings

Rafts:

Supports:

Resolution:

200

Infill:

Filament: PolyMaker PLA

Category: Costume

Derelict Lightsaber Hilt from Star Wars: The Od Republic

by ReProps · original on Printables ↗

Costumes & Accessories / Cosplay & Costumes in general

♥ 291⬇ 659🖨 14 prints

License: Creative Commons — Attribution ↗thingiverseswtor

Print profiles

Derelict_Saber_Grip.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Derelict_Saber_Pommel.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Derelict_Saber_Emitter.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Derelict_Saber_Emitter_Casing.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Derelict_Saber_Clasp.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print