Updated v2: The box around the people was a bit off center top to bottom. It has now been fixed.

After messing around with some of the other The Office signs, none of them were quite right.

Here is my attempt at creating the The Office sign, and my first attempt at modelinganything.

I'm using two separate processes, but a pause between layers should also work.

If you aren't squishing your first layer, you should change the filament at 2 mm. That’s layer 10 with a .2mm layer height, layer 20 with a .1mm layer height. If you resize it, you’ll have to find the right change point.

Want to have The Office Sign but don’t have a 3D printer? You can buy them from qualitygoodsstore12 on Etsy.

Category: Signs & Logos