The makita charger doesn't come with any keyholes on the back to be able to mount it to the wall. This little print solves the problem by replacing the stock feet with ones having a screw hole protruding the base of the charger.

I designed this to be printed and sold in my small webshop, thus it's as small and prints as quick as possible while maintaining function and strength.

You are free to print and sell this, but please attribute this me and I'd appreciate if you don't remove logos.

Installation

Take note not to damage your charger or short anything.

Remove the original rubber feet and insert the 3D printed feet in each hole. To increase the grip I suggest you add a few rounds of electrical tape to the print. Use a screw to expand the plastic part and make it grip the inside of the charger. Make sure the screw isn't too long! A 3.5x15mm works for me, depending on how much tape I put on.