Credits for the origin Design to Puhsketti!


I edited so it will fit Ø5x2 mm Magnets and used it as a Ring box for my engagement!



Fabric Inlay:
I used this foam for the padding and this fabric for the cover. I know that the sizes and the amount of the foam and fabric are a lot more than needed but I didn’t had cheaper options available for less material  

Print 3 FRONTpanel.stl and 3 BACKpanel.stl. Insert the m2 screws through the first panel, then 3 washers, then screw directly into the other panel.

I printed mine at 0.1mm layer height and a 0.4mm nozzle.
Filament is Black Carbon Fiber Nylon. Try to avoid elephant's foot, because it will make your joints sit at funny angles and the final box won't look as nice.