Will write description later, too tired, but wanted to get this all out there for everyone to use.
(you'll have to print “FrontLoader_TopCover” twice)
You can find the lid here: https://www.printables.com/model/110082-nes-frontloader-lid
And the controller here: https://www.printables.com/model/117352-nes-controller-shell-replacement
Update 10/21/2024
I was told some of the mounts weren't lining up at all - I am not sure what caused this error, but I have now updated and re-uploaded a version that will work (tested against an OpenTendo board).
Update 3/12/2022
I had a report some pieces (Controller & Top covers) weren't perfectly aligned with the originals, so I went back over everything and did an update to make sure all dimensions are accurate. Files for the top shell and cover have been updated.
NES Frontloader replica Shell
by RetroGameRevival · original on Printables ↗
Gadgets / Video Games
♥ 232⬇ 2.4k🖨 3 prints
Print profiles
FrontLoader_ControllerPortCover.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Frontloader_ShellTop.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
FrontLoader_TopCover.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Frontloader_ShellBottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print