The little bear who’s got some heart!

The heart is printed separately and works best in a contrasting color. It’s a very loose fit in the bear’s chest, you can leave it as is and swap the heart with the season, or add a touch of glue to make the love endure.

Print Instructions

• Bear
  • Print as is.
  • 15% infill is plenty, could probably go 10% and be fine.
  • Tested with 0.4 nozzle and 0.2 layer height
  • Larger nozzles may struggle with overhangs.
• Heart
  • Print upside down, standing on its ends.
  • Use 5 or 6mm brim to ensure it stays put.
  • Minor cleanup from removing the brim is all that’s needed.
  • Tested with 0.4 nozzle and 0.2 layer height
  • Larger nozzles may struggle with overhangs.

This is a remix of two clean low-poly designs (linked), I just cleaned up the bear and made room for a little bit of love.

• Update - Feb 13 2023
  • Fixed odd void inside the bear, thanks (Pheggas)