I recently went on a plane trip and found some little phone clips. Looking at them, they're just some injection molded plastic, and unfortunately, one broke in my bag while I was loading my car. So, I fused the two pieces together with a lighter, took some pictures of it, made a model, made a few changes to make it more suitable for printing, and now I have a replacement that's much cheaper. I made a few changes so that the print doesn't warp, and for durability. Based on the design of this.

Use it by slotting it into the seat back folding table. Please do not use during takeoff or landing (Common sense, but just putting this here for liability). It should hold just about anything, unless you hang something from it. 

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3 Pro

Rafts:

Doesn't Matter

Supports: 

No

Infill:

50%

Filament:

Sunlu PETG

White

Notes:

You can print in PLA or ABS/ASA, but with PLA I recommend using a 100% infill. It'll just help with durability. Make sure it sticks well to the plate, the small parts can be terrible sometimes.

Category: Mobile Phone