This is a good print in place canagar. Put the stick in the little notch on the bottom of the body, add the funnel on the top to load your favorite thing to smoke. Then use the plunger to pack it down. Once filled pick the packed tobacco or weed out by the stick and roll it on up.
Then pull the stick out… don't smoke that, that would be dumb.
Please like and review, I'll make changes based on requests.
Enjoy!Â
Print in Place Canagar (Blunt Rolling Tool)
by Nick · original on Printables ↗
Hobby & Makers / Other Ideas
♥ 328⬇ 1.9k🖨 7 prints
Print profiles
Stick.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Funnel.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Plunger.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Body.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print