Inspired by https://www.prusaprinters.org/prints/63523-laptop-stand I created this stand that raises the laptop a bit higher.
It is compatible with Prusa Mini and I printed it with Prusament PLA Galaxy Silver with 0.2 layerheight, no top & bottom layers, 12% honeycomb infill, 4 perimeters.
The result is nice and sturdy… However, because of the notches, you cannot close the laptop in the stand – if some requests it, I might provide a version w/o a notch, as I feel it's not really required.
Update v1:
As of popular request I added a connector. I recommend printing it with 0.2 layerheight, no infill & 3 perimeters. It should have a preassure fit into the triangle slots. If you have a larger printer, you can scale it up, it currently just about fits into the Mini's print volume. (I don't need the connector and haven't tried it. Please provide a feedback in the comments regarding the fit!)
Update v2:
Asof request I added a Version w/o the Lid.
Laptop Stand
by finke · original on Printables ↗
Gadgets / Computers
♥ 1.8k⬇ 15.5k🖨 159 prints
Print profiles
Laptopstand.stlIN STOCKDEFAULT
⏱ 58m · 47 g · 169 × 112 × 20 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
Connector_v1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Laptopstand_no_lid.obj
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print