You will need:
About one and a half inches of rope (ؽ" or Ø13mm)
Glue
List of parts to print :
- 1 Body
- 2 Feet
- 3 Eyes
- 4 Wind-up Key (supports need it)
- 5 Wick-Holder
Recommended orientation for printing as the image shows .
Instructions:
Stick with glue as the picture shows.
This 3D model is heavily inspired by the drawing of Francisco Perez Pac23
https://www.behance.net/gallery/4848205/2012-Stuff/modules/38323901
Bob-Omb (Bomb super Mario)
by Horacio · original on Printables ↗
Gadgets / Video Games
♥ 376⬇ 1.6k🖨 18 prints
Print profiles
5 Wick Holder.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
4 Wind-up Key.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
3 Eyes.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
1 Body.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
2 Feet.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print