Simple 2 piece holder for up to 8 wrenches, in my case for 6 - 22mm.
There are 2 models, each with different hook position - offset by 20mm. This means you can put them in any column of holes on the Skadis board, depending on lenght of your wrenches.
Files ends with “1” and “2” for different hook position, print one of each or both the same.
This design works with 2 hooks, which is easy to install and remove, but holds very well thanks to the small bumps on the hooks:
Print instructions
- I used PLA, but any material should do
- No supports needed
- 4+ perimeters for added stiffness
- 3MF file with both models + 6 perimeters
IKEA Skadis - Wrench holder / Držák na klíče
by Many24 · original on Printables ↗
Hobby & Makers / Organizers
♥ 381⬇ 2.0k🖨 55 prints
Print profiles
Ikea_Skadis_wrench_hook v6_2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Ikea_Skadis_wrench_hook v6_1.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Ikea_Skadis_wrench_hook.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print