28/8/23 Added step file for battery holder to aid with remixes

2 versions, a single battery and a triple battery version. Prints vertically, no supports

Important note on scaling

As the fit of the battery is so precise I would advise printing the single version first to test fit.

Mine were printing at 100% on a Prusa mk2s. However most people seem to be getting best results at 105%. I've now added the “bestfit” versions that are pre-scaled to 105%

** Remember to de-burr any edges which may affect the fit.

Also note that I printed all of mine in PETg, which is more flexible than PLA, and therefore you may need to upscale slightly to achieve a good fit in PLA

Dewalt battery holder

by IR Blinx · original on Printables ↗

Hobby & Makers / Tools

♥ 3.1k⬇ 27.4k🖨 162 prints

License: Creative Commons — Attribution — Noncommercial ↗batterydewaltbatteryholdernosupports

Print profiles

DWbattholderV4.stlIN STOCKDEFAULT
⏱ 1h 11m · 28 g · 62 × 19 × 88 mm · 1 material(s)
Prints on: A1 mini 0.4PLA
Order this print
DWbattholderV4x3.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
DWbattholder-x1bestfit.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
DWbattholder-x3bestfit.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print