Parts for my 5 Inch quadrocopter build.

The parts are for a clone of the GEPRC Mark4 frame:
https://www.banggood.com/custlink/KvvEZ5HHEp

Some of the parts should fit to the original frame, too but at least the front bumper won't fit (holes are 1mm too far apart).

GEPRC Mark4 Clone Frame Parts [WIP]

by DomesticHacks · original on Printables ↗

Hobby & Makers / RC & Robotics

♥ 52⬇ 898🖨 4 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗gpsquadrocopterfreestylemark4

Print profiles

front_bumper.STLDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
rear_bumper.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
gps_mount.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
receiver_mount_rxsr_10.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
receiver_mount_rxsr_6.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
receiver_mount_rxsr_8.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
antenna_tube_small.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
pigtail_flat.STL
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print