Print at about 0.2mm layer height

PLA recommended, PETG works fine too but the stringing might be more noticable

If you experience issues that the hanger-ring is lost during slicing, activate “Detect thin walls” in “Print Settings” - “Layers and perimeters". Note that this setting is only visible if you are at least set to “Advanced” in the top right corner.

Snowflake

by Andi · original on Printables ↗

Seasonal designs / Winter & Christmas & New Year's

♥ 148⬇ 1.7k🖨 30 prints

License: Creative Commons — Attribution — Share Alike ↗snowflakessnowflakesnowchristmasornamentchristmastree

Print profiles

snowflake2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
snowflake1.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print