parts needed
- White PLA or PETG
- Glue
- Batteries
- White lights with battery holder (I used these)
- 2mm foam
Assembly
- Make 3 rectangles of 2x1 cm from the foam and stick them as in the photo. Take the lights and put them through the hole and press the battery holder in place.
2. Press the middle tree (2) into its slot and use hot glue to hang the light on it. It should look something like this. Note that for the best result you should orientate the lights towards the tree. I did not use all 20 lights, I cut the rest.
3. Press the small tree (3) and the deer (5) into its slot and glue the big tree (1) to the back. then it should be ready.
If there are any problems, send me a message and I will do my best to help. Good luck and have fun printing
Christmas decoration
by Pieter · original on Printables ↗
Art & Design / 2D Plates & Logos
♥ 2.4k⬇ 6.1k🖨 80 prints
Print profiles
Deer (5).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Big tree (1).stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Middle tree (2).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Small tree (3).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Bottom (4).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print