A jig to hold a zipper slide while threading bulk zipper tape through the slide.

There are two options, with and without a weighted base.

Fusion 360 file included for your convenience. Note: the weight cavity and weight filling hole extrusions are suppressed. Right-click those extrusions in the timeline and un-suppress if you want them enabled.

Printing

Filament: Prusament PETG Carmine Red
Layer Height: 0.15mm Quality
Perimeters: 3
Infill: 20% Rectilinear
Supports: None
Ironing: Yes, All Top Surfaces (Optional)

Assembly

Weighted Base Option
- Fill the weight chamber with #8 (2.3mm) steel or lead shot.
- Seal the hole with epoxy.
- Hint: Avoid using hot glue, it stays hot too long and can distort the PLA.
Optionally, add some felt to the bottom.

Zipper Slider Jig

by Rod · original on Printables ↗

Hobby & Makers / Tools

♥ 299⬇ 2.0k🖨 16 prints

License: Creative Commons — Attribution — Share Alike ↗sewingzipperzipperbagpfaffberninajukisewingaidzipperslidezipperjig

Print profiles

jig_without_weight.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Zipper_Pull_Jig.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
jig_with_weight.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print