This is a GPU anti sag support holder. It is designed to be as minimalistic as possible. It is intended to be used with Fractal Design Meshify 2 Compact case, but it can work with other cases close in shape and size. Similar metal-made supports can be found for purchase on Amazon, but they are eirher too short or too long to work with my case, then I made this version so that it fits. In the bottom part there's a housing for two 5x5x5 mm neodimium magnets, so that it can be magnetically attached to the bottom of the case. You can also put an adhesive rubber pad on the top, thus to preserve the graphic card from scratches. Its screw mechanism allows to adapt its height from a minimum of 5 cm to a maximum of about 7,5 cm (the Meshify 2 Compact clearance from the bottom of the case to the bottom of the graphic card is about 6,5 cm). I suggest you to print it in PETG, ABS or other heat resistant plastics; avoid PLA since it can get quite hot inside a PC case.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

No

Supports:

No

Resolution:

0.2 mm

Infill:

30%

Filament:
Prusament PETG Jet Black Category: Computer