This STL is a combination of the top and bottom halves of the original model. I found it difficult to get the top and bottom perfectly aligned when printed in four parts. This is simply printed in two parts (print same part twice) and glued together. The wand ends up being 388.8 mm long which did not fit on my Taz 6 bed. I cheated by indicating the print bed was 285mm x 285mm in Cura. Then I printed with the wand corner to corner. The print was without any skirt/brim and 100% infill using ColorFabb woodfill.

Print Settings

Printer Brand:

LulzBot

Printer:

TAZ 6

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

100%

Filament:
colorFabb woodFill wood filament Wood/Light brown Category: Props