If you like, throw a hungry student a Tip so i can make more cool stuff! :) https://paypal.me/jpal85

40x14mm, 3mm thick base. Uses M3 hardware.

Prints fine without supports at 0.2mm. Takes about 24 minutes at 65mm/s.

Some off brand XT60's seem to require a little patch of electrical tape or something on the bottom to hold it secure. My originals fit fine.

Print Settings

Supports:

No

Resolution:

0.2

Infill:

50+

Filament: add:north Economy white

Notes:

Prints fine without supports.
Perhaps use rafts if you want.

Category: Electronics