Remix to hold a piece of 1.75mm filament as the lightsaber.
The original piece was very big to be considered a "mini".
This height of my model is 7cm.
I advice not to shrink it further down (or enlarge it a lot) if you want to use the filament as the lightsaber.
Note: The red filament lightsaber is not printed. ;)
| Posting a make and liking the model is much appreciated! |
Mini Dart Vader with filament lightsaber
by TravockMD · original on Printables ↗
Art & Design / Sculptures
♥ 157⬇ 1.3k🖨 34 prints
Print profiles
filament-vader-fixed.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print