🖨️ Print Shop
Twisted Torus (soluble supports torture test)

A small torture test for printing with soluble supports. The inside of the torus is hollow, but the holes on the surface are quite small. This geometry was created to see how well PVA dissolves in hard to reach cavities.

The print in the photo was made using PrimaSelect PVA+, which in general did dissolve, but left some fine strings inside the geometry and especially around the holes.

Print Settings

Printer Brand:

Prusa

Printer: 

i3 MK3 MMU 2

Rafts:

Doesn't Matter

Supports: 

Yes

Resolution:

0.2mm

Infill: 

15%

Filament:

Generic PLA PLA, PVA 

Notes:

The supportmaterial should be dissolvable. For a print with PLA chose PVA.

Twisted Torus (soluble supports torture test)

by alecs.form · original on Printables ↗

Learning / Math

♥ 165⬇ 993🖨 6 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗prusatestgeometricgeometrymmu2smmu2torturetestmathprusai3mk3prusai3mk3mmu2pvatestprintthingiversemathematicssolublesupportmathartgeometricaltorustorusknottwistedtorus

Print profiles

  • 200612_twisted-torus.stlDEFAULT

    ⏱ time and weight estimated after preparation · 1 material(s)

    Made to order: we prepare this file when you order, which adds a few minutes before printing starts.

    Prints on: A1 mini 0.4PLA

    Order this print