Little brother of the regular Turbocharger which you can find on my page. No additional hardware is necessary. Just super glue or resin.

Attention:
I made the Mini Turbo with a resin printer (Elegoo Saturn). I don´t know, if you can make it on a filament printer (FDM). I would love to see you guys proof me wrong and see somebody getting it out of a FDM printer.

Watch out that you don´t glue the base plate upside down to the body!

It works perfecty fine on the Elegoo Saturn to print it without rafts and support flat on the bed. But that´s up to you to figure it out yourselfs.

Print Settings

Printer:

Elegoo Saturn

Rafts:

Supports:

Filament: Elegoo Resin ABS like / water washable White / Green

Category: Other

Mini Turbocharger Whistle

by DaRealRadioactiveMan · original on Printables ↗

Toys & Games / Building Toys

♥ 212⬇ 2.3k🖨 6 prints

License: Creative Commons — Attribution — Noncommercial ↗whistlekeychainturbothingiverseturbocharger

Print profiles

MiniTurbo Boden Thalmann.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
MiniTturbo Welle Thalmann.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
MiniTurbo Gehäuse Thalmann.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
MiniTurbo Impeller Thalmann.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print