Quick and dirty combination of the following models :
- keycap : https://www.thingiverse.com/thing:4571242
- shank : https://www.prusaprinters.org/prints/35594-tight-cherry-mx-cap
I also modeled a 2u key.
There are some artifacts I did not have time to clean from the original shank and the models are messy.
But with PrusaSlicer and an FDM printer I did not notice any issues.
Flat MX Keycap
by Shib Mc Ne · original on Printables ↗
Gadgets / Computers
♥ 301⬇ 2.5k🖨 24 prints
Print profiles
keycap_2u.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
keycap_1u.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
keycaps_1u_2u.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print