Hidden Airtag Saddle Holder

This is a handy holder that keeps your airtag hidden and safely attached to your bicycle.
This is not a clip-on to make it harder to remove, instead the two halves are held together with four screws.
The bottom part clips onto the saddle bars and the screws then lock it in place and prevent easy removals.

I remixed this because the original one did not fit onto my saddle and I didn't like the clip-on approach. For this one, your bars need to be 40mm apart at one point and each bar extends outward at an 9° angle.

Please leave a comment if you want other distances/angles and I can upload them too.

Part-List:

4x m2x12 (or longer)
4x m2 nuts (nyloc nuts also work)

Airtag bicycle hidden saddle holder

by Transmitt0r · original on Printables ↗

Sports & Outdoor / Outdoor Sports

♥ 193⬇ 864🖨 1 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗applebicyclebikesaddleairtagairtags

Print profiles

airtag_bicycle_holder_bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
airtag_bicycle_holder.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
airtag_bicycle_holder_top.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print