Modified version with snap-in friction fit. No screws or threading required.
The fit is a little bit tight to make sure that the feet doesn´t come lose by accident.
Update: The locking tabs were a bit too tight for modern motherboards that strictly adhere to the standards.
If you have problems whith the tabs braking off when removing or inserting the feet, please try the “slim fit” version below. The diameter of the tabs is ~0,5mm smaller than the original ones and require the mounting holes to be Ø3,96mm/0.156" to remain in place if the motherboard is lifted up.
Snap-in motherboard feet (standoffs) for desktop use
by Printing Programmer · original on Printables ↗
Gadgets / Computers
♥ 368⬇ 2.0k🖨 11 prints
Print profiles
Motherboard foot snap-in.3mfDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Motherboard foot slim fit.3mf
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print