This one piece case for AirTags is very easy to print and doesn't requires any supports. The holder fits tight. Inserting and removing the AirTag needs a little force.

The holder in the pictures are printed on a Prusa Mini with very fine settings (0.05mm), took 40min and used a little more than 1g of filament. Printing it on a standard 0.2mm works as well and will take around 10min.

Print Settings

Printer:

Prusa Mini

Rafts:

Supports:

Resolution:

0.05mm

Infill:

Filament: DasFilament PLA

Category: Mobile Phone

AirTag Case Keyring holder

by gimpelginster · original on Printables ↗

Gadgets / Portable Devices

♥ 586⬇ 3.1k🖨 67 prints

License: Creative Commons — Attribution — Noncommercial ↗casetagapplethingiverseairtag

Print profiles

AirTag Case.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
AirTag Case double connector.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
AirTag Case vertical connector.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print