You can now print it on the sloped, upper side to get a much better look!

I could reduce the print time and used material by using the shell-command.

If you use the textured PEI-sheet, you might get a nice finish on the upper side.

So I was looking for a fitting cupholder for my BMW E90 tray and couldn't find one which wasn't too big.

This one fits to your BMW E9x without the big navi and without the iDrive knob. I made 3 versions which can fit 250ml, 330ml or 500ml cans (Germany/EU). With the big one, the walls might get too thin.

This was designed to be printed with PLA.

If you like the design, leave a tip :)

How I Designed This

I modeled this in Fusion360 with a scanned version of the orignial tray.

Some more details on reddit:

Scanned original tray

Modelling the cupholder from the existing tray model

Cupholder V2 for BMW E90 E92 E93 etc.

by flatsixguy · original on Printables ↗

Hobby & Makers / Automotive

♥ 196⬇ 2.1k🖨 13 prints

License: Creative Commons — Attribution — Noncommercial — Share Alike ↗cancupholder500mltray3cupholderbmwdose330mle90e92flatsixguy250mlgetraenkedosediesdasananas3seriese91e93

Print profiles

Cupholder_E90_ 330or500ml_66mm_v2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Cupholder_E90_ 330ml_sleek_59mm_v2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Cupholder_E90_ 250ml_57mm_v2.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print