Simple honeycomb end pieces I made for a monitor stand. Dimensioned for 1.5 cm thick plywood or similar. About 17.5 cm deep.
I uploaded a version without and two versions with brackets. I also made a middle brace that can be put in the back to avoid sagging shelves if you make it very wide.
Print instructions
I upped the bed temp to try to avoid warping in the corners. You can also try to warm the bed longer before printing to ensure it is properly warm all over, and print in an enclosure.
I printed in PETG to avoid sagging on a hot summer day, and used three perimeters for added strength.
Honeycomb monitor stand
by Erl · original on Printables ↗
Household / Office
♥ 2.5k⬇ 4.2k🖨 26 prints
Print profiles
monitor-stand-with-bracket.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
monitor-stand-no-brackets.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
monitor-stand-middle-brace.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
monitor-stand-with-two-brackets.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print