This is a remix of "shoe horn | no support" by cashew675, which you can find here: https://www.thingiverse.com/thing:4119614

I liked the original design very much and especially the fact that it could be printed on the side, as this means the layers follow the natural direction of movement of the foot thus minimizing friction during operation.

I found the original too small, so this remix is just a non-homogeneous scaling of the original STL.

The version you see on the photos was printed more than six months ago and has been used several times per day since then. To give it maximum strength I printed it using PETG with 0.2mm layers and 5 external perimeters. This pretty much ensures the print is a completely solid chunk of plastic. And just like the original, it can be printed without supports.

Enjoy!

Print instructions

The version shown was printed in PETG with 0.2mm layers, 5 external perimeters and no supports.