Summary
Slim RJ45 Ethernet Cap / Coupler that will save your ethernet cables and especially the plastic retaining tabs on your ethernet cables in bags cluttered with other cables.
There is one open ended file to customize to your requirements, a cap and two couplers, one with the tabs on the same side, one with them flipped.
The models all feature sacrificial bridging and should print fine without any supports. The Bridge must not droop too much, since there is only 0.6mm of clearance to the locking surfaces. The Bridge has to be removed carefully using a knife or flushcutters for the parts to be usable.
Slim RJ45 Ethernet Cap / Coupler/ Clip protector
by mathiaspl20 · original on Printables ↗
Gadgets / Computers
♥ 102⬇ 1.0k🖨 14 prints
Print profiles
Connector_Clip_guard_RJ45 v6_Connector_Clip_guard_RJ45 v6_closed_.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Connector_Clip_guard_RJ45 v6_Connector_Clip_guard_RJ45 v6_open_.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Connector_Clip_guard_RJ45 v6_Connector_Clip_guard_RJ45 v6_two_opposite_side_.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Connector_Clip_guard_RJ45 v6_Connector_Clip_guard_RJ45 v6_two_same_side_.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print