For those of us who can't paint, I remixed the ornament to a multi-color version.

The 3MF is scaled up to be about a 3.5" ornament. I wanted a decent sized print to be shown with pride on our tree. As an added bonus, it makes it a little easier for the MMU2S to print.

Print instructions

There are some supports needed, but only for the whiskers on the side really. Switching to white always takes a lot of purge material so I recommend setting that value quite high. It's more wasteful to have to print the model twice than to have a purge value not high enough and have to print again. It's happened to me too many times.

This is the first time I used the "No sparse layers" on the purge tower. It worked well, saved a bit of filament and print time. The included GCODE file uses this. If you choose to use the included GCODE, the filament colors loaded are as follows:

1 - Light Green
2 - Dark Green
3 - Yellow
4 - Red
5 - White