Quick wall mount to hang golf clubs on. It might have issues with older steel shafts, and the pressure fit can be a little tight, but it seems to work adequately
It realistically probably doesn't need 6 screw anchors i was initially worried that the pressure fittings would slowly work it off the wall, 2 probably would've been plenty with 4 being safe.
The bottom piece I installed about 30 inches below to keep the shafts relatively straight
If its a set of blades, the hosel usually is wider and taller, and the club will sit at the base of the shaft.
-Shorter length clubs will be a little stiffer in the mount since the shaft usually widens up towards the handle
Golf Club Wall Mount
by Mike C · original on Printables ↗
Sports & Outdoor / Indoor Sports
♥ 204⬇ 1.1k🖨 5 prints
Print profiles
golfclubholder_v3.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
golfclubshaft_holder.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print