Side panel to construct a (stackable) shoe rack from 18x200mm wood boards.

Fits exactly on an MK3(S) printbed.

The model is customizable on OnShape via variables.

This is a re-model for metric wood boards of the original: https://www.thingiverse.com/thing:4676909

Print instructions

• PETG
• 9 perimeters

If you're printing on an MK3/4: Since this just fits on the printbed you need to:

• Disable skirt
• "Place on Face" on the "backside" (i.e. so that the cutout is towards the front of the bed)

To get the open honeycomb look:

• Zero top / bottom layers
• Infill: 
  • Honeycomb, 5%
  • Infill angle: 0º