A simple playing card holder I made for my daughter.
Fusion360 file and short how to change the name in the pictures 💪🏻
Update
Since the top layer is not flat it always printed with small "stairs"
To get rid of this I rotated the X axis in PrusaSlicer 10° upwards and activated supports
This got me a nice top layer, but the bottom was not very even…
My first idea was to use an ironing iron to make it nicer, but since I still had an unopened roll of TPU filament I decided to print an additional layer (thanks to the comment of EGBrader!) to glue on the bottom (2 different .stls are only the diameter of the circles, 12 mm is a very tight fit, I used 11 mm and more glue ^^)
For this I also created small holes in the bottom
Print instructions
I printed it with no supports and 15% infill in Prusament PETG or PLA
The TPU I used was no-name and in PrusaSlicer I selected "Generic FLEX"
Playing Card Holder
by tokyo2ooo · original on Printables ↗
Toys & Games / Board Games
♥ 791⬇ 3.2k🖨 42 prints
Print profiles
Playing Card Holder blank.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Playing Card Holder with holes on bottom.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Playing Card Holder TPU bottom 11 mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Playing Card Holder TPU bottom 12 mm.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print