A wallet:

• easy to print
• easy to use
• easy to carry

Take care of your cards and documents so that they do not bend.
Quick access to all your cards.
Hold coins and money.
Fits easily in a pocket
*A full print takes around 6 hours
Damaged parts are easily replaceable (CardHolder, LockPin, Hinges)

Can print it in to sizes:

• Slim for standard credit card size
  Internal size 60.4 x 95.6 mm
  external size 76.0 x 110.0 mm

• Normal for wider cards and documents.
  Internal size 67.6 x 95.6 mm
  external size 83.2 x 110.0 mm

Versions:

• Fully 3D printable version --- with a lock pin to secure the wallet. The files that you have to print are:
  1 x Body.stl/BodySlim.stl PLA
  1 x LockPin.stl PLA
  1 x CardHolder.stl TPU/Flex
  3 x Hinge.stl PLA
  Additional parts
  A piece of flex filament (400 mm)
  A piece of PLA filament (10 mm)

• Magnets version --- with magnets insert to secure the wallet. The files that you have to print are:
  1 x BodyMagnets.stl/BodyMagnetsSlim.stl PLA
  1 x CardHolder.stl TPU/Flex
  3 x Hinge.stl PLA
  Additional parts
  A piece of flex filament (400 mm)
  2 x neodymium rectangular magnets (4x4x2 mm)
  *Make sure to add a pause command in the GCODE to insert the magnets (M600 or M601) at 9.8 height

Assembly instructions

• Take the body part with the deepest rail and insert a piece of flex filament around the part
• Put together the body parts and insert the hinges with some pressure (press in a flat surface like a table)
• Take the cardholder printed in flex material and insert gently into rails all the way inside the wallet
• It is done!!

For fully printable version:

• Take the lock pin, insert in the body side with the little hole for the lock pin and put a piece of PLA filament to secure them.

Print instructions

Body files Print with non flexible material like PLA
layer height: 0.2 ( For better finish results use variable layer height at 9.4 mm with a layer resolution of 0.1 )
No supports required
Perimeters: 3
Minimun shell thickness: Top/Bottom 1 mm
Detect thin walls: activated
Fill density: 15%
Fill patern: Gyroid
Bottom Fill pattern: Hilbert Curve
*For bodyMagnets files add a pause (M600 or M601) at 9.8mm height to put the magnets

Hinge Print with non flexible material like PLA
layer height: 0.2
No supports required
Perimeters: 3
Minimun shell thickness: Top/Bottom 1 mm
Detect thin walls: activated
Fill density: 15%

LockPin Print with non flexible material like PLA
layer height: 0.2
No supports required
Perimeters: 3
Minimun shell thickness: Top/Bottom 1 mm
Detect thin walls: activated
Fill density: 15%

CardHolder Print with flexible material like TPU
This is a kind of challenging print but not to much, so slow down because of the thin walls and flexible material.
*If your print have holes in the sides because the material dont stick together don't worry it works as well
layer height: 0.2
No supports required
Perimeters: 1
Minimun shell thickness: Top/Bottom 1 mm
Detect thin walls: activated
Fill density: 95%
Fill Patern: Rectilinear
Extrusion multiplier: Increase a little (+ 0.02)