I liked the idea of a honeycomb pattern to freely organize screwdrivers and other things from toya (https://www.thingiverse.com/thing:3018389)

But the solution had some flaws which forced me to redesign it.

This can be printed without any support. I tested it with 0.25 and 0.20 on my Prusa Mini and it works.

If you want to have the hooks with a clean bottom finish, support needs to be added for hooks.

Otherwise, it is recommended to extend the perimeter. 4 outer shells are especially important to keep the hooks in place and strong enough :)

Based on a user comment, this works with Mastercraft Pegboards too.

Pegboard Screwdriver Holder

Hobby & Makers / Organizers

♥ 575⬇ 4.5k🖨 46 prints

Print profiles

Pegboard Screwdriver Holder (6.5mm honeycomb and 4mm base).stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Pegboard Screwdriver Holder (7mm honeycomb and 4mm base).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Pegboard Screwdriver Holder (6.5mm honeycomb and 5mm base).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Pegboard Screwdriver Holder (7mm honeycomb and 5mm base).stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print