Lego Differential that prints in 2 parts.
Nozzle: 0.25, 0.4mm are OK (printed both)
Layer Height: 0.1, 0.15mm are OK
v2:
1. The Gear now has deeper wells for the Arm to fit in. 2. Changes were made to make the part much stronger. 3. The inner gear locations and pegs are centered.
Print instructions
This print has two supports made in the model so that supports are not needed.
The Arm is inserted into the Gear wells. Using glue is highly advised.
Suggested Material: PETG
Lego Differential v2
by SirCabbages · original on Printables ↗
Toys & Games / Building Toys
♥ 393⬇ 2.4k🖨 4 prints
Print profiles
Arm.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
Gear.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print