Check out my Amazon Page to see what kind of gear I use to make these models!
This was designed to be used as a classroom exercise to teach students about 3D printing, math, and design all at once.
Print out these blocks and assemble them to learn about fractions and 3D printing.
Print out the following:
1x: Block_Base
2x: 1-2
3x: 1-3
4: 1-4
5x 1-5
I printed this on a Lulzbot Taz 6 using Amazon Basics PLA filament.
Fraction Blocks, Teachable Classroom Math Manipulative Model!
by Andrew_Sink · original on Printables ↗
Learning / Math
♥ 229⬇ 1.0k🖨 4 prints
Print profiles
1-3.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
1-2.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
1-4.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
block_base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
1-5.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print