In oldtime, when people couldn´t make spears yet and the nights were darker than your frightening imagination, Crystal Dragons ruled the world. They flew without fear through the world. They loved magic crystals that gave them invincible power. Until ...
Print instructions
The dragon bust was designed primarily for DLP/SLA printers. It was reduced to 50% of its size. I recommend to print it in a position like on the sreenshots of a slicer. You don´t have to put any supports under thorns. I recommend to make a hollow model and place holes in the correct positions. A little force is needed to set the jaw. Beware of its breaking. I printed it on my Anycubic Photon. I used a new Ameralabs AMD-3 Grey resin with these print parameters:
6 bottom layers
60 bottom exposure time (s)
0.03 layer thickness (mm)
4.4 normal exposure time (s)
CRYSTAL DRAGON
by Vlado Turek · original on Printables ↗
Art & Design / Sculptures
♥ 1.5k⬇ 5.3k🖨 33 prints
Print profiles
dragon_base_solid.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
dragon_jaw_solid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
dragon_head_solid.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print