This is a 40% scaled down version of my other clip. Some modifications were made to conserve the correct clearances after scaling. This version is can be pretty hard to print, and is likely very weak. It's mostly just for fun.

If you're looking for an actual clip that can hold stuff, check out the original.

Horizontal gaps are just over 0.1mm after scaling, so you'll need a pretty good printer to get all the parts moving.

Print instructions

Supports should be set to "Support on build plate only".

0.15mm layer height should be used.

If you're using the STL, you'll have to scale it down to 40% yourself.

You might have to use a brim if it starts to curl off the print bed.