Tri-Tower Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has a deep well bottom feeder in the rear tower allows you to water your plant from the bottom. The soil will wick up the water as needed to the roots of your plant.

This was printed using 3D Solutech PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.

3D Solutech PLA: https://amzn.to/2GcU2bt

My Printer: http://amzn.to/2BBYP4t

If you like this thing, then check out my other things: https://www.thingiverse.com/Qrome/designs

Print instructions

Category: Containers Print Settings

Printer Brand: Monoprice

Printer: Maker Select

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%

Filament: 3D Solutech PLA Grey
Notes:

No supports required -- scale it up as needed.