This is a rethink / remix of the Tower Water Tank Planter Pot -- I have enjoyed the side water tank planters so much and I wanted to add just a bit more to this design.

Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has a deep well feeder on the side that allows you to water from the side of the pot. The soil will wick up the water as needed to the roots of your plant.

It has an alternate fill spout on the side of the tower that runs the water through an inside the pot via a water aqueduct to the tank / well.

This was printed using 3D Bizard 3D Tech Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.

Bizard 3D Tech Wood PLA: https://amzn.to/2IwVWSr

My Printer: http://amzn.to/2BBYP4t

Print instructions

Category: Containers Print Settings

Printer Brand: Monoprice

Printer: Maker Select

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%

Notes:

3 line walls and 1.2mm thick on all sides