Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has the over water drain in the lower level. If you see water there, you have watered too much. The bottom vents allow the soil to breathe.

This was printed using 3D Mars Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.

Overture Matte Light Brown PLA:  https://amzn.to/3C9JIxr

Finished with Sedona Red Minwax: https://amzn.to/2mWSszV
With a clear coat of satin clear spray: https://amzn.to/2LFHgXr
You can get the Minwax and Satin Clear spray from a local Home Depot.

Print instructions

Category: Decor Print Settings

Printer: Maker Select

Rafts: No

Supports: No

Resolution: 0.2

Infill: 20%

Notes:

Used 3D Mars Wood PLA and stained it with Min Wax followed by a satin clear coat.