A phone stand for both Android and iPhone (Tablets should work, but might be a bit wobbly!), that has an integrated slot under the phone for a charging cable.

You can reverse the positioning of the cable so that it is the correct orientation for your device (Android micro USB users).

The hole for the cable is a little larger than a typical cable. I have tried a few and it fitted, but if yours does not fit you could either sand/file down the inside, edit the attached SolidWorks model for your specific cable, or use something like a soldering iron to slightly (and carefully!) enlarge the hole.

Print instructions

Category: Mobile Phone Print Settings

Printer: Craftbot Plus

Rafts: No

Supports: Yes

Resolution: 0.3mm

Infill: 25%

Notes:

REMEMBER TO ROTATE ON ITS SIDE
So that it doesn't need to use loads of support.

How I Designed This

SolidWorks Design

Uploaded is the SolidWorks model I created for this object. Within it you should be able to see the steps I took to create this model.