This is a remix of the lovely "Ebony Dagger (Skyrim)" model by Shadowcraft. Thanks, Shadowcraft!
I have made the following changes to the original:
- Scaled up the dagger so that overall length is now about 40 cm.
- Trimmed the base of the blade and made a hole for it in the handle so it's a bit sturdier and easier to assemble.
Made holes in the tip of the blade so that it fits on the pegs on the blade base.
The finished print shown in the pictures had some supports fail on the handle, and I also had trouble getting the very tip of the blade to print. Both of these issues were with my printer and not the model.EDIT 4/19: Added the dagger as one single piece "dagger whole.stl"
Print instructions
Category: Props Print Settings
Printer Brand: Prusa
Printer: i3 MK2S
Supports: Yes
Resolution: 0.2
Filament: 3DFillies ABS
Notes:
A brim is also needed. This print used a brim of 5 mm.
Ebony Dagger from Skyrim by Shadowcraft remix
by VoxInaudita · original on Printables ↗
Costumes & Accessories / Props
♥ 366⬇ 1.7k🖨 14 prints
Print profiles
blade_tip.stlDEFAULT
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
handle_rotated.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
blade_base.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print
dagger_whole.stl
⏱ time and weight estimated after preparation · 1 material(s)
Made to order: we prepare this file when you order, which adds a few minutes before printing starts.
Prints on: A1 mini 0.4PLA
Order this print