I made a phone stand that ended up working nicely as a Nintendo Switch stand as well. I wanted something that had plenty of clearance to allow a device to be plugged in without putting too much stress on the cable or the plug outlet on the device.

I have a Google Pixel 3XL with a big beefy Otterbox case and it suits it just fine. The stand is wide enough to not be easily knocked over.

The U-shaped notch on the back is for Popsockets.

It will need supports for obvious reasons.
I print them with 10-15% infill.
I superglue a thin piece of EVA foam on the bottom to prevent slippage.

Print instructions

Category: Gadgets